6 Steps to Handle a Broken Car Window Yourself
If you are like most people, you may not feel like handling a broken car window yourself. But it is important that you get it repaired as soon as you can. Whether your car window is shattered or smashed, you should handle the problem right away.
In most cases, you can drive your car with broken glass, but you must get it repaired or replaced without wasting time. In this article, we are going to guide you on how you can do it yourself. Read on to find out more.
Supplies you need
- A pair of thick gloves
- Masking tape
- Microfiber piece of clothing
- A plastic trash bag
1. Prepare the glass
First of all, you should wear a pair of work gloves for safety. Your next move is to purchase a bag or container that will make it easier for you to collect broken glass pieces.
2. Remove the Broken Glass
Next, you should collect the large pieces of broken glass. And then put all of the pieces into the container or bag. Now you should break away the rest of the broken pieces attached to your vehicle.
Next, you can use a vacuum cleaner to clear the remaining tiny pieces of glass from the window frame and inside of your car. With the vacuum, you can reach even the most difficult-to-reach areas in the carpet inside your car.
3. Clean the Window
Your next move is to prepare the surface surrounding the chipped area for adhesion. Make sure you clear away any dust, dirt, and buildup. If you follow this step, it will help to ensure that the tape will stick to the glass.
Use a damp piece of clothing for cleaning the window seal and the frame of the car. Now, wait for a few minutes to let the area dry.
4. Adjust the Plastic Covering
Position the plastic covering on the window frame from inside your vehicle. Hold the bag or container against the upper edge of the glass frame and get it fixed in place using masking tape.
It is not a good idea to use other types of tape or you might end up damaging the paint of the car.
5. Secure the Covering
Now, get at least 6 pieces of tape, apply some pressure to make the plastic flat. Now, pull it in the direction of one side of the car frame. Make sure you use only one piece of masking tape to attach the plastic to the window family.
6. Seal the Covering
Finally, you should apply a few more pieces of tape for reinforcing the seal. With another layer of tape, you can strengthen the plastic covering. Besides, you should make sure that there is no hole amidst the window frame and the plastic. The idea is to prevent water or air leakage.
In short, we suggest that you follow these steps if you want to handle the broken glass of your car. Hopefully, these tips will help you get the job done without making serious mistakes.
Article Source: http://EzineArticles.com/10503216